OEM frozen jobs??

[eddieh]

Anyone out there experience hung jobs which state "Started" in OEM?

I created a backup job which runs just fine in OEM 2.2. Then I added a "Run OS Command" before the backup to delete the previous night's backup set.

When I run the job it shows that it started but it just sits there. If there is an error I would like it to fail so I can see the log but its just sits in a hung state which is useless.

thx in advance,
-Eddie Hernandez

[sambavan]

Did you apply the patch EM_2.2_1374495 to OEM 2.2. You must apply that patch before you submit any backup jobs through OEM. Be aware the patch number vary from platform to platform.

IT can be obtained from oracle's ftp site.

Good luck,
Sam

[Edited by sambavan on 03-26-2001 at 04:15 PM]