Shared install to Full Install?
DBAsupport.com Forums - Powered by vBulletin
Results 1 to 3 of 3

Thread: Shared install to Full Install?

Hybrid View

  1. #1
    Join Date
    Nov 2000
    Location
    greenwich.ct.us
    Posts
    9,092

    Question

    Can anybody point me to some documentation that describes how to change a module that is "shared" to a module that is "Fully installed" for 11.5.3? I found a document on metalink that outlines the procedure for 11.0, but I am not sure if the steps are the same...
    Jeff Hunter
    marist89@yahoo.com
    http://marist89.blogspot.com/
    Get Firefox!
    "I pledge to stop eating sharks fin soup and will not do so under any circumstances."

  2. #2
    Join Date
    Nov 2000
    Location
    greenwich.ct.us
    Posts
    9,092
    After much poking around, I found that your can change your install options via adaimgr.
    Jeff Hunter
    marist89@yahoo.com
    http://marist89.blogspot.com/
    Get Firefox!
    "I pledge to stop eating sharks fin soup and will not do so under any circumstances."

  3. #3
    Join Date
    Apr 2001
    Posts
    8

    Lightbulb

    In 11 you use adaimgr to change shared to full.
    In 11i everything has become much easier, just run the license manager tool and register the required module as being fully installed. After this you should generate forms,reports,messages for this module as they are not yet compiled.

    To run license manager go to your common directory (e.g. SIDcomn)/admin/assistants/licmgr and run the application LicenseMgr (You need X for this!).

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  



Click Here to Expand Forum to Full Width