+ Reply to Thread
Results 1 to 3 of 3
  1. 12-14-2000 12:09 PM #1
    rara
    rara is offline Junior Member
    Join Date
    Oct 2000
    Posts
    32

    Library

    Hi (sorry about the mispell)

    I am trying to set up an environment using Dev2000 R.2.

    I installed the software. I can open forms in the builder, but cannot run them. I get the following error:

    FRM:40039 Cannot open form, library cannot be attached.

    The thing is, I attached the library and compiled...still same error.

    Any advice...or direction?

    Thank you.

    [Edited by rara on 12-14-2000 at 12:11 PM]
    Thanks,
    Rara.
    Reply With Quote Reply With Quote
  2. 12-14-2000 01:35 PM #2
    wizia
    wizia is offline Junior Member
    Join Date
    Dec 2000
    Posts
    1
    Compile the library seperately and deattach the libarry and reattach the library. When attaching don't port the directory/address of the libarry
    Try this
    Wizia
    Reply With Quote Reply With Quote
  3. 12-15-2000 12:45 PM #3
    mber
    mber is offline Member
    Join Date
    Oct 2000
    Posts
    123
    Just in case: make sure they are in the same path and specified the path in register.

    Take care
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules

 Click Here to Expand Forum to Full Width